1. Separate the two halves of Fuel Optimiser.

Identify the fuel incoming line. This can be

done by finding the fuel filter and following

the fuel pipe to the engine. The incoming line

can usually be identified because it has more pressure and is colder. When it is difficult to find
the pipe it is advisable to resort to the mechanic
and ask them to indicate the right pipeline.

2. Next, set the seal as shown in the figure

so that the opposite side remains open and

allows for the fuel pipe to be surrounded.

.

3. Once the two halves have been set to wrap

the fuel line, make sure the device, if installed

in a plastic or rubber line, is at leat 25 mm. away from any metal item in the fuel line. Make sure

all the magnets have been set in parallel.

4. Next, put the seal through the opposite side,

put it through the fastener at the end of the seal

and make sure both halves have been properly

adjusted. The halves do not have to touch each

other. If that occurs it means the device has

not been properly adjusted on the pipe. If this

occurs, replace the pipeline.

Beställ